Technical Specification; Ordering Information; Ul Compliance Section - RISCO Group WatchOUT eXtreme 315DT Instrucciones De Instalación

Detector externo de dupla tecnologia
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 35

Technical Specification

Electrical
Current consumption
Voltage requirements
Alarm contacts
AM contacts
Dust output
Physical
Size: LxWxD
Weight
Environmental
RF immunity
Operating/Storage temperature
* PIR technology is limited in rough environmental conditions.

Ordering Information

Standard Units
Model
WatchOUT 315DT
Note
:
Each of the detectors contains a standard swivel and 3 replacement lenses (P/N engraved on the Lens) 1.7m
low installation pet (RL300F), long-range (RL300R) and barrier lens (RL300B).
Accessories Kits
Model
RA300B
RA300P
RA300C
RA300HS
RA300SC
Camera Option
Model
WatchOUT VC1
WatchOUT VC017
WatchOUT VC053
WatchOUT VCPS
WatchOUT VCPS

UL Compliance Section

To comply with UL, note the following:
♦ The unit is intended for outdoor installation where unwanted alarms are tolerable. If not, it
is recommended to connect it to the trouble circuit of a listed compatible control unit.
♦ A dead zone of 5 ft should be considered during installation.
♦ The camera option is not UL listed.
♦ Disclaimer: PET feature has not been tested or verified by UL.
♦ 0.6 power factor inductive load can be used on the relays.
♦ Relay mode is intended to be connected to listed compatible control unit or power supply that provides 4
hours of standby power.
♦ It may be necessary to set detector at maximum sensitivity to achieve maximum distance.
♦ Do not connect the DUST output to a UL listed product.
♦ When the detectors are connected to the BUS of the ProSYS panel, the detectors are to be powered
from either the ProSYS (Version 7.55) panel or a listed compatible burglar alarm power supply that has
an output voltage range that does not exceed 9-16 vdc, has a minimum of 4 hrs. of standby power, and
is suitable for mercantile use.
12
30mA at 12 VDC (Stand by)
42mA at 12 VDC (MAX with LED ON)
9 -16 VDC
24 VDC, 0.1A
24 VDC, 0.1A
Open collector 70mA max
230 x 123 x 124mm (9 x 4.8 x 4.88 in.)
0.632 Kg (1.4lb)
According to EN50130-4
-30°C to 60°C (-22°F to 140°F)
Description
WatchOUT DT + Swivel
Description
WatchOUT Barrier Swivel Kit
WatchOUT Pole Adaptor Kit
WatchOUT Conduit Adaptor Kit
WatchOUT Demo Housing
WatchOUT Swivel Metal Conduit Adaptor
Description
WatchOUT Camera Cover Adaptor
WatchOUT Narrow Camera
WatchOUT Wide Camera
WatchOUT Camera 220V Power Supply
WatchOUT Camera 120V Power Supply
WatchOUT 315DT Installation Manual
Weight
0.1 Kg (0.23 lb)
0.25 Kg (0.55 lb)
0.6 Kg (1.27 lb)
- -
1Kg (2.2 lb)
Only P/N:
RK315DT00USB
is UL approved

Publicidad

Tabla de contenido
loading

Tabla de contenido