Fuel Specifications; Handling And Transport - Palazzetti ECOFIRE Serie Manual De Instrucciones

• Do not clean the stove until the structure and ash
have completely cooled down.
• Touch the door only when the stove has cooled
down.
• Perform all operations without haste, in such a
way as to ensure maximum safety.
off using the procedure.
procedure.
•
touch the painted parts during operation to avoid
damaging the paintwork.
3

FUEL SPECIFICATIONS

3.1 FUEL SPECIFICATIONS
Pellets (Fig. 3.1) are made from various types of
mechanically compacted wood in compliance with
environmental protection standards. Pellets are
the only fuel that can be used on this type of stove.
vary in relation to the type and quality of pellets
used.
The features of the natural wood pellets made
class A1 according to ISO 17225 2 (ENplus A1,
DIN Plus or NC 444 category "NF Wood Pellets
Biofuels Quality High Performance".
The stove has a pellet hopper with the capacity
Booklet enclosed.
The pellet hopper is located at the top of the stove.
It must always be able to be opened to load the
pellets, and must remain closed during operation.
Due to temperature control requirements, operation
on traditional wood is not possible.
The stove must not be used as a rubbish incinerator.
3.2 STORING THE PELLETS
The pellets must be kept in a place that's dry and
not too cold.
It's suggested to keep some sacks of pellets in
the same room where the stove is installed or an
adjacent room, as long as the temperature and
humidity are acceptable.
Damp and/or cold pellets (5°C) reduce the fuel
heat value and mean the burn pot (unburned
frequently.
Pay special care when storing and handling the
sacks of pellets. Make sure these are not crushed
to prevent the pellets from becoming sawdust.
Sawdust introduced into the hopper may block the
pellet feed system.
Use of poor quality pellets may affect normal pellet
stove operation and render the warranty void.
INSTALLATION
4
4.1 REMOVING THE STOVE FROM THE
00 4777020 -09/2018 - PALAZZETTI - PN - Italy
HANDLING AND
TRANSPORT
The stove is delivered complete with all parts
included.
Beware of the tendency of the stove to tip over.
The stove's centre of gravity is towards the front
of the appliance.
Always keep this in mind when moving the stove
on the transport pallet.
When lifting avoid jolts or sudden movements.
Make sure that the forklift capacity exceeds the
weight of the stove being lifted.
The operator of the forklift or other hoisting
equipment is responsible for lifting the loads.
Prevent children from playing with the packaging
suffocation!
PALLET
To remove the stove from the transport pallet
follow the instructions shown in the "Product
Booklet" enclosed.
fig. 3.1
21