Before Use; Handling Of The Packed Machine; Unpacking Of The Machine; Squeegee Assembly - ADIATEK ruby 50e Manual De Uso Y Mantenimiento

GB

BEFORE USE

HANDLING OF THE PACKED MACHINE

The machine is supplied with suitable packing fore-
seen for fork lift truck handling.
The total weight is 91 kg.
Packing dimensions:
Base: 118 cm x 67 cm
Height: 119 cm
ATTENTION:
Do not place more than two packings on top of each
other.

UNPACKING OF THE MACHINE

1. Remove the external packing.
2. Unscrew the brackets that secure the machine to
the pallet.
3. Move the machine forwards, as indicated in the
figure, avoiding heavy contacts to mechanical parts.
4. Keep the pallet for eventual transport.

SQUEEGEE ASSEMBLY

With the squeegee support lowered, slide the two
stud bolts (A) placed on the upper part of the squee-
gee, inside the slots on the support. Block the squee-
gee by rotating the lever (B) clockwise.
Insert the squeegee hose (C) into its coupling, re-
specting its position as indicated in the figure.

ADJUSTMENT OF THE SQUEEGEE HEIGHT

The squeegee must be adjusted in height depending
on the rubber wear. In order to guarantee a perfect
drying during the operation, the lower blade of the
rear squeegee rubber (D) must work slightly bent
backwards (operator side) in uniformed way in all its
length.
Acting clockwise upon the two registers (E) it is pos-
sible to increase the bending of the rubber. Acting
counterclockwise it is possible to decrease the rubber
bending.
The label (G) indicates the rotation sense to increase
or reduce the height.
Note: The wheels of the squeegee support must be
adjusted through the registers (E) at the same height
so that the squeegee works parallel to the floor.

ADJUSTMENT OF THE SQUEEGEE INCLINATION

In case of need, to increase the rubber bending in
the central part, it is necessary to tilt the squeegee
body rotating counterclockwise the register (F). To
increase the rubber bending on the squeegee ex-
tremities, rotate the register clockwise.

SPLASH GUARD ASSEMBLY

The two splash guards have to be assembled onto the
brush base group. Insert the metal strips inside the
suitable slots present on the rubber. Place the round
hole at the flat extremity of the strip onto the screw
placed in the front part of the brush base group. Se-
cure the strips through the nut blocking it.
17
Screw down the knobs in the rear part of the cover
in the free extremity of the metal strips. The opera-
tion has to be carried out for both splash guards.
With the brush assembled, the splash guard must
slightly touch the floor.

MANUAL ASSEMBLY OF THE BRUSH

ATTENTION:
Check that the mains plug is disconnected.
1. Take off the squeegee.
2. Lift the support raising the lever.
3. Rotate backwards the machine until it rests on
the support wheels, so to lift the brush base.
4. With the brush base group in lifted position, in-
sert the brush into their plate seat underneath the
brush base turning it until the three metal buttons
are properly seated in their slots; rotate energically
the brush to push the button towards the coupling
spring until it gets blocked.
The figure shows the rotating sense for the brush
coupling.
GB