Installing An Expansion Card - Dell EMC PowerEdge R230 El Manual Del Propietario

Figure 55. Removing the expansion card from the expansion card riser
1 PERC card
3 touch point (2)
5 LED connector on the system board
7 LED connector on the PERC card
Next steps
1 Install the expansion card.
2 Install the expansion card riser
3 Follow the procedure listed in the After working inside your system section.
Related links
Removing the expansion card riser

Installing an expansion card

Installing the expansion card riser
Installing an expansion card
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Remove the expansion card riser.
Steps
1 Locate the expansion card connector on the riser.
2 Holding the expansion card by its edges, position the card so that the card connector aligns with the connector on the expansion card
riser.
104 Instalación y extracción de los componentes del sistema
2 expansion card connector on the riser
4 expansion card riser
6 LED cable