Publicidad
Idiomas disponibles
Idiomas disponibles
of the appliance, the connection of the appliance with the power
supply must be done by means of a minimum IP55 system, as per
the standards HD 384 CENELEC for Europe, or international IEC
60346-7-708 1988, and the standard AS/NZS 3000 (Australian wir-
ing rules).
• Means for disconnection must be incorporated in the fixed wiring
in accordance with the wiring rules.
• Avoid to touch the metal parts.
3. LOCATION
All irradiation heaters are designed to achieve and maintain a certain
thermal comfort to the people who need it both outside and inside. It
is therefore very important to carefully study the area where people
stay and consequently direct the radiation towards them.
The Sharklite range of heaters is deliberately designed to be very
flexible in the choice of position. There are the following basic op-
tions:
Wall mounting version — fig. 2. Before drill the holes for the dow-
els, be sure that the wall is solid and that you are far from water
tubes or electrical wires. Apply the aluminium bracket on the wall
and mark the holes position with a pen or a screwdriver. For fixing
the appliance at the wall, drill two holes with a 5 mm diameter bit
and fix the aluminum bracket with the dowels and screws that you
find in the box. Then fix the appliance to the wall bracket using the 2
screws with dowels. Check that the arrow on the label is turned up.
Ensure that the supply cable is well mounted and that it does not
come into contact with the reflector of the heater or that it does
not trail into the heated area. The supply cable can be fixed to the
aluminum bracket behind the reflector with plastic wrappers.
4. USE
The Sharklite range consists of a 1200 W heater and an 1800 W heat-
er. The essential element of the heater is the halogen filled quartz
linear lamp with a tungsten element. The heater operates at full out-
put almost immediately. The heating reaches a distance of about 3
meters in front of the appliance.
13
Publicidad
