Greencut GLM680SX Manual De Instrucciones página 60

60
• Regularly inspect the lawnmower and ensure that all grass deposits are removed from the
underside of the chassis.
• Regularly lubricate the axle of the chassis and the bearings using a suitable lubricant.
• Regularly inspect the condition of the blades because they have a signifi cant effect on the
performance of the lawnmower. Blades should always be sharp and balanced.
• In regular intervals, check that all nuts and bolts are tightened. Nuts and bolts that are worn out
or incorrectly tightened may cause serious damage to the engine or the frame.
• If the blade strongly impacts an obstacle, stop the lawnmower and take it to an authorized
service Centre.
• BLADE: the blade is made from pressed steel. To achieve the best possible mowing results,
regularly sharpen the blades, approximately after every 25 hours of operation. Check that the
blade is always correctly balanced. To do this, insert a steel axle (with a diameter of 2-3 mm) into
the middle hole. If it is correctly levelled, the axis will remain in the horizontal position.
• If the blade does not remain in the horizontal position, replace it.
• When removing the blade, screw out the bolt, check the load bearing part of the blade. If the
parts are worn out or damaged, replace them.
ATTENTION
Always use only original spare parts. Poor quality spare parts may cause serious
damage to the lawnmower and create a safety hazard.