Language Selection - Perle REG-PRO RX Manual Del Instalacion

CONTROLLER'S CONNECTIONS
STAND BY (STOP)
Push and hold the ESC/SBY button for 2 seconds during the functioning to put the controller in stand
by mode:
1) The power to the electrical socket is turned off
2) Green on led blinks.
3) If the functioning is PROPORTIONAL the display shows: "Stop 0%" on the first row and the current
measure on the second row (see figure on the left side)
3) If the functioning is Manual or ON-OFF the display shows: "Stop" and the % programmed on the
first row and the current measure on the second row (see figure on the left side)
Push again the ESC/SBY button for 2 seconds to return the controller to the programmed functioning.
MENU TREE

LANGUAGE SELECTION

Push and quickly release CAL button and then pressing + and – buttons select the language
choice. Push CAL to enter the language submenu and select "Language English" by pressing
+ or - .
Push CAL to confirm the choice and ESC to go back in measuring.
WARNING:
MEASURE TYPE CHOICE
A – Power cable, 230 V- 50Hz (upon request : 115 ~ )
D - BNC connector for pH or Orp(Rx) probe.
E - ON_OFF switch. OPTIONAL
If, after a mistake in programming, the measure was changed in pH type, follow next
instruction to come back to mV measure type:
Push and quickly release CAL button and scroll the menu using + and – buttons till
the display shows "Measure Type". Push CAL to enter the submenu and then by
pressing + and – button choice Rx measure.
Push CAL to confirm and ESC to go back in measuring.
Cod. 00.008.574 Rev 1.0
Push and quickly release CAL
button during the functioning to enter
into the programming menu.
Push + or - button to navigate
through the menu.
Push the CAL button to enter the
submenus.
WARNING: DO NOT ENTER THE
SUBMENUS: "Measure Type" and
"Restore Enter" BECAUSE THEY
ARE RESTRICTED.
 RESTRICTED
13