Cleaning The Spray Gun Filter; Cleaning The Inlet Filter - Titan XL255 Manual Del Propietário

Tabla de contenido

Idiomas disponibles

Spraying Troubleshooting -

The filter must be cleaned every time you use your sprayer. When using thicker spray materials, the filter might need to

be cleaned more often.

NOTE - the LX60 threads are left-handed. Turn the filter

clockwise to remove, and counterclockwise to replace.

1. Perform Pressure Relief Procedure, page 7.

2. Unclip the trigger guard from the filter housing by pulling

outward from the filter housing. Unscrew the filter

housing.

3. Remove the filter from the spray gun housing and clean

with the appropriate cleaning solution (warm, soapy

water for latex paints, mineral spirits for oil-based

materials). For spray gun model LX60, the filter will

need to be unscrewed from the gun housing (turn

clockwise).

4. Inspect the filter for holes (see inset, right). Replace if

holes are found.

nOTE - nEVER POKE THE FILTER WITH A SHARP

InSTRuMEnT!

5a. Model LX05 - Replace the cleaned filter, tapered

end first, into the gun housing. The tapered end of

the filter must be loaded properly into the gun.

Improper assembly will result in a plugged tip or no

flow from the gun.

5b. Model LX60 - Screw the tapered end of the filter into the

gun housing (turn counterclockwise to tigthen).

6. Reassemble the spray gun.

Spraying Troubleshooting -

The screen at the bottom of the suction tube may also need cleaning. Check it every time you change spray containers.

1. Remove the filter by unscrewing it from the suction tube.

Clean the filter with the appropriate cleaning solution

(warm, soapy water for latex materials, mineral spirits for

oil-based materials).

2. Thread the filter back into place.

If after completing all of the steps in Spraying

Troubleshooting you are still experiencing problems

spraying, refer to the Troubleshooting section (page 22).

English