Cleanup For Latex Materials - Titan XL255 Manual Del Propietário

Cleanup -
5. Unclip the return tube from the suction tube and place it
into the waste container. Turn the PRIME/SPRAY knob
to PRIME.
7. Place the original material container next to the waste
container. Aim the spray gun into the side of the
original material container and hold the trigger.
Waste
container
Containers should
be touching
9. When cleaning solution flows from the spray gun, keep
holding the trigger and aim the spray gun into the side of
the waste container.
10. Trigger the gun until the fluid flowing out of the gun is
clear. You may need to empty the waste container and
continue flushing.
11. Turn the PRIME/SPRAY knob to PRIME and trigger gun
to relieve pressure.
Move on to Cleaning the Spray Gun Components.
English
Latex materials (continued)
6. Turn water supply on. Turn pump ON (l). Water will go
into the suction tube and out through the return tube.
Let pump run for a few minutes to allow the return tube
to be flushed.
8. While pulling the trigger, turn the PRIME/SPRAY knob
to SPRAY to purge material from the hose back into the
original container.
Hold trigger
Original
material
container
Keep holding trigger through next steps.
14
Spray water into
waste container
Spray material
into original container
Leave pump running
through steps 7 and 8.
SPRAY