Promax 8 SE Manual De Instrucciones página 84

Freq. Mode: It allows you to change the measurement signal among ANL
(Analogue), DIG (digital) and LEV (Power Level).
Freq. Step: It allows you to change the step of frequency. This is put into
practice when you are using the rotary knob to change frequency.
Audio Mode: There are four options to receive the audio signal: LEVEL, AM, FM,
OFF.
In LEVEL mode, the instrument beeps depending on the power
input.
In AM mode, you can listen to AM (Amplitude Modulation) radio
signals.
In FM mode, you can listen to FM (Frequency Modulation) radio
signals.
In OFF mode, the loudspeakers are off.
In Digital measurement mode, the options available on the Configuration menu
are next:
Freq. Mode: It allows you to change the
measurement
ANL (Analogue), DIG (digital)
and LEV (Power Level).
Freq. Step: It allows you to change the step
of frequency. This is put into
practice when you are using the rotary knob to change frequency.
Channel BW: It allows you to change the channel bandwidth.
Noise Freq.: It allows you to change the noise frequency.
Noise mode: In this mode there are three options: AF (frequency offset), BW/S
(half the bandwidth), FREQ (noise frequency).
Remark: When switching from frequency to channel, if the tuned frequency does not
correspond to any channel, the
nearest to this frequency and will stay tuned to this channel. This operation
may take a few moments.
Page 30
USER'S MANUAL.
signal among
Figure 30.- CH-FR configuration.2/2.
PROMAX-8
SE
PROMAX-8
will search for the channel
09/2013
SE