Installation; General; Fastening - De Dietrich MPLC 150 Manual De Instalación, Puesta En Servicio Y Mantenimiento

5 Installation

5 Installation
5.1

General

5.2

Fastening

42
● The boiler/tank assembly must be installed in a frost-free area. The
ability to position the tank as close as possible to the draw-off points
minimises energy losses from the pipes (which should be insulated in
any case).
● This document must be placed somewhere visible close to where the
appliance is installed.
● The tank must be fitted to enable maintenance operations and periodic
checks to be performed without having to disassemble the tank
assembly.
Warning
- Installation, commissioning and maintenance operations
must be performed by an approved technician, in line with best
practice and according to this document.
- The appliance must be regularly serviced to ensure that it
works reliably and safely.
- To benefit from warranty cover, no modifications must be made
to the domestic hot water tank.
- Heating water and domestic water must not come into contact
with each other. In particular, domestic water must not be
circulated by the exchanger.
● The internal wall to which the appliance is fixed must be able to bear
the weight of the appliance when filled with water. If the interior wall is
suitable but thin, it can be reinforced with plywood.
● Depending on the configuration chosen (vertical installation, horizontal
installation or installation on tripod, see chapter on "Dimensions"), fit the
necessary hardware (ø 10 mm) using the drilling template supplied in the
package.
● Attach the MPLC tank onto the hardware, paying attention to the
direction of fitting (see the section on "Installation").
Note
If the tank is fitted on a tripod, (supplied separately on request) it
is highly recommended to fix the upper bracket to the wall.
7649662 - v02 - 24032016