Phase Sequence Indicator; Measurement Procedure And Results Of " " Mode - Amprobe MultiTest 2000 Manual De Usuario

AMPROBE
If the instrument can't
generate the Nominal
Test Voltage it will
emit a long beep and
displays a screen
similar to the screen
to the right.
The displayed result can be stored by pressing the SAVE key twice (refer to
paragraph 9.1).
6.3. :

PHASE SEQUENCE INDICATOR

Turn the rotary knob to the
6.3.1. Measurement procedure and results of "
1. Connect the Black, Red and Green connectors of the split cables to their
corresponding input terminals of the instrument B1, B2, B3.
MΩ 05.06.01
ν 1.17 Ω
M
107V 15s
MAN 500V
FUNC VNOM
position.
MULTITEST2000
Insulation Resistance
ATTENTION: the
resistance R was taken at a
ISO
voltage value lower than the
set rated voltage.
insulation case.
occurs under low
conditions or in the presence of
capacitance on the installation.
Test Duration
" mode
test of
Low
This case
insulation