Overview Of The Display Functions; Express Programming - Vimar ELVOX RS14 Manual Para El Conexionado Y El Uso

3.3 Overview of the display functions

LED displays in operating mode
Photocell beam interrupted
Door moving towards OPEN position
Door in OPEN position
Door moving towards CLOSED position
Door in CLOSED position
Reference point is switched
Permanent actuation of an external control
element
Remote control is actuated
Operating voltage
3.4

Express programming

Advice:
For proper initial operation of the operator system, the express programming procedure must be carried out.
This applies for the initial operation and after resetting.
Preconditions
The following conditions must be assured before express programming can commence:
- the door must be in the CLOSED end position.
- the carriage must be connected up.
Advice:
When programming the OPEN and CLOSED door positions, the reference point must be passed.
The controls are programmed using the plus (+), minus (-) and (P) buttons.
If no buttons are pressed within 120 seconds while in programming mode, the controls revert to operating mode.
A corresponding message is displayed.
Reference:
The messages are explained in Section 9.
EN
Legend:
LED off
LED on
LED flashes slowly
LED pulses
LED flashes quickly
Factory default setting
Not possible
Removing the cover panel.
17