Application/Limitation - ICAN 20-100 Instrucciones De Uso

20-100/ 300 JULI 02 REV. 01. (GB)
3 (GB)

APPLICATION/LIMITATION

If the polluted air's oxygen content is 17-21% (volume), ICAN FULL FACE can
be used with a gas, particle or combined filter. Use an oxygen meter to ascertain
the oxygen content of the air. Follow the filter's instructions for use carefully. The
filter must be equipped with a standard thread connection approved in accordance
with EN 148-1.
If the oxygen content of the air is less than 17% (volume), or if the gas
concentration exceeds the maximum allowable gas concentrations in relation to the
gas filter class used, as shown in table 4 (see page 10), an air-supplied respirator
which is independent of the surrounding air must be used. This equipment must be
equipped with a standard thread connection approved in accordance with EN 148-
1. Follow the instructions for use for the equipment carefully.
If the user has certain physical features (such as a beard or thick sideboards), then
the ICAN FULL FACE might not give a satisfactorily tight fit to the face. This will
also apply if spectacle frames obstruct the facial seal. In such cases, the user carries
the risk of damage to his health.
In areas where the use of respiratory equipment is necessary, there is often a danger
of explosion. If this is the case, then the relevant precautions must be observed.
Leave the area immediately, check the mask and replace parts if:
1. The mask, parts thereof, or filters are damaged.
2. Breathing difficulties occur.
3. Dizziness or indisposition occurs.
4. Pollution can be tasted or smelt, or other irritation occurs.
ICAN FULL FACE must never be modified or altered.
 copyright 2002