Commissioning; Installing Stud Collector / Stud Securing Cap / Stud Discharge Tube; Installing Different Nosepieces - Honsel BZ 103 A Instrucciones De Uso

3 Commissioning

WARNING
Parts flying out of the machine
Serious injuries or material damage
• Do not point the machine
towards persons.
• Stand behind the stud collector
or stud securing cap during
operation of the machine.
• Empty the stud collector at
regular intervals.
• Disconnect the machine from
the energy and media supply
systems before changing tools
or accessories.
• Wear impact-resistant protec-
tive goggles when operating the
machine.
• Clamp the workpiece securely
before starting work.
• Always test the stud holder
before starting work.
WARNING
Hazards from compressed air
Serious injuries or material damage
• Disconnect the compressed
air supply during all work steps
for cleaning, maintenance
or during replacement of
components.
• Do not point the machine
towards persons.
• Secure hoses and lines to
prevent them from uncontrolled
whipping.
• Keep cold air away from your
hands.
• Do not exceed the maximum
working pressure indicated
in the technical data; use a
pressure reducer, if necessary.
• Do not use the hoses or lines to
carry the machine.
• Switch off the compressed air
supply immediately in the event
of damage to hoses or lines.
38 | English
WARNING
Lack of protective equipment
Serious injuries or even death
• Use only undamaged protective
equipment.
• Wear ear protectors during all
operating work steps.
• Wear protective goggles
during all work steps for
commissioning, operation,
cleaning, maintenance or during
replacement of components.
• Wear protective gloves
during all work steps for
commissioning, operation,
cleaning, maintenance or during
replacement of components.
WARNING
Unauthorised accessories
Serious injuries or material damage
• Use only OEM accessories
from HONSEL.
• Read and observe the
information in the operating
manual before operating the
machine.
Some accessories can be
purchased in our shop
www.niet24.de.
3 .1 INSTALLING STUD COLLECTOR /
STUD SECURING CAP / STUD
DISCHARGE TUBE
Precondition:
• The stud collector / stud securing cap / stud
discharge tube is undamaged.
• The tool is disconnected from the compressed
air supply.
1. Unscrew the installed stud collector / stud
securing cap / stud discharge tube.
2. Screw on stud collector / stud securing cap /
stud discharge tube securely.
3 .2 INSTALLING DIFFERENT
NOSEPIECES
The structure of the machine is
described in Chapter 2.4.