Compact Discs - Denon DCM-5001 Instrucciones De Operación

ENGLISH
Playback
1. Check the connections between all the components and the ID number settings of the different units (set with the mode
switches), then turn on the power.
Do not turn on the power switch of the main unit before turning on the power of the sub units. (It is necessary for the
*
main unit to recognize the other unit.)
The numbers of the currently connected sub units appear in the "PLAYER"
area of the DCM-5000's fluorescent display, indicating that the sub units are
recognized as sub units.
Example: When a total of three units are connected (one DCM-5000 and
two DCM-5001s): "1", "2" and "3" light.
2. Once the above is completed, the DCM-5001s can be operated in the same way as the DCM-5000 using the keys on the
DCM-5000's front panel or the remote control unit. (For details, refer to the DCM-5000's operating instructions.)
The system can be used as a CD changer with a maximum of 600 discs, and various operations can be performed (disc files, group
playback, etc.).
* Before turn on the daisy chain system, be sure to check that the each unit's door is closed.
If you turn on the power with any unit open, its unit and the lower sub units can not be recognized as the part of the daisy
chain system.
* If you once open the door of one unit (main or sub unit) in the system, the daisy chain system stops its operation. Close the doors
in order to restart the operation of the system.
* If you once turn off one of the unit (main unit or other sub unit) during operation, the system cannot be operated properly.
So in this case, once turn off all the units and turn on the power of all the units again.
* Do not turn off the sub units during playback in any case. It will produce the noise from the audio output due to unusual
condition of the system.
* If the connection cords (daisy chain control cords or digital audio cords for daisy chain) are not connected properly. Error message
"Error 0*80 000" or "Error 1000 000" (* is a number code) appears on the display under circumstances.
If this happens, once turn off all the units of the system and check that the each connection cords are properly connected or not.
After correct the connection, turn on the power of the each unit again.
(If the problem persists, contact your store of purchase)
About the error code in daisy chain
*
If the error code appears on the DCM-5000
system, the player No. that caused the error is also showed on the
display.
Example: Error in the 1st sub unit.
In this case, open the door of the displayed player depends on the error type. (For details, please refer to the DCM-5000's
instruction manual.)
Close the door after check the disc, etc.
Once turn off the power of all units and turn on the daisy chain system again.
8

COMPACT DISCS

1. Cautions in Handling Compact discs
• Do not get fingerprints, oil, dirt or other substances on the
compact disc. If the disc becomes dirty, wipe it off with a
dry, soft cloth.
• Do not clean compact discs with benzene, paint thinner,
water, record spray, anti-static agent, silicon cloth or similar
substances.
• Take particular care to prevent scratches to the back side of
the compact disc when removing it from the case and
when inserting it in its case.
• Do not bend compact discs.
• Do not apply to compact discs.
• Do not attempt to enlarge the center hole of the disc.
14
's display in the daisy chain
Flashes
• Do not write on the label (printed) side of the disc with a
ball point pen or pencil.
• Bringing a CD into a warm room from a cold place could
cause moisture to condense on the disc surface. Do not
attempt to dry the disc with a hair dryer, etc.
2. Storage of Compact Discs
• To prevent dust, scratches, deformation, etc., be sure to
store compact discs in their case.
• Do not store compact discs in the following locations.
1. Places where direct sunlight strikes for long periods of
time.
2. Places with a high humidity or a lot of dust.
3. Places reached by heat from a heater or similar
appliance.
PLAYER
1 2 3
PLAYER
1 2 3
PLAYER
1 2 3
PLAYER
1 2 3
DCM-5000 (Main unit) display