Petsafe PDBDT-305 Manual Del Dueño página 6

Placing the Collar on Your Pet
Place receiver collar on your dog with the receiver hanging directly beneath
your dog's neck. Adjust the collar securely so that the probestouch the skin
of your dog's neck. Make sure the collar is not so tight as to cause discomfort.
When the collar is properly adjusted, you should be able to place one finger
between the probes and the dog's skin.
Caution: Do not leave collar on too tight. Doing so can cause
Pressure Necrosis, a condition that results in skin deterioration.
Check your pet's collar regularly. Remove the collar weekly and wash
your dog's neck and probes with mild soap (approved by a veterinarian).
If a rash or sores form, take the collar off for a few days. When replacing it,
make sure that it is not too tight.
Maintenance
• Check batteries (weekly)
• Clean probes and dog's neck with veterinarian approved soap and warm
water (weekly).
• The batteries will last up to 30 days depending on the frequency of use.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a residential environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur
in a practical installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Unauthorized changes or modifications to the equipment, not approved by
PetSafe, could result in not meeting compliance with FCC regulations and could
void the user's authority to operate the equipment.
6