Sub-Zero UW-24 Manual Del Usuario página 6

M ODE L UW- 24 | UW- 2 4 F S I N S TA L L AT I O N
Anti-Tip Bracket
M ODE L UW- 24F S
The back of the anti-tip bracket must be installed 24
from the front and centered behind the unit. Refer to
(625)
the illustration below. Refer to page 16 for wood and con-
crete floor applications.
ANTI-TIP BRACKET
Anti-tip bracket (UW-24FS)
|
6 Sub-Zero Customer Care 800.222.7820
Custom Panel
M O DE L U W-2 4
5 / " For overlay applications, a custom door panel must be
8
installed. Panel size is critical for a proper fit. To verify the
panel requirements and dimensions, refer to the Sub-Zero
Design Guide at subzero.com/specs.
Finish all sides of the custom panel. They may be visible
when the door is open or through the glass door.
The custom overlay door panel is attached using the screws
provided, through the door frame. The screw locations are
marked on the back of the custom panel using tenon cen-
ters inserted into the holes of the door frame.
With the unit secured and door closed, hold the custom
panel in the desired position on the door. Lightly tap the
front of the panel to locate the mounting positions. Remove
the tenon centers. Refer to the illustration below.
The door frame has mounting holes to accommodate
Sub-Zero accessory handles. If the handle mounting holes
are not used, the handle should be attached to the custom
panel prior to mounting. The screw heads may need to be
countersunk into the panel for proper alignment.
To mount the custom panel, open the door and use the pre-
drilled holes to position the panel. Drive the screws into the
panel through the black tape on the door frame. The screw
holes are hidden behind the door gasket. Use as many
screws as necessary to secure the custom panel. Refer to
the illustration below.
PANEL
Tenon center
DOOR
GASKET
FRAME
TENON CENTER
Door frame cross section
13
/ "
32 (11)
DIAMETER
GLASS
1
/ "
4 (6)
DIAMETER