Erreka LINK-GSM Guía De Instalación, Configuración Y Uso página 25

LINK-GSM
Guide for installation, configuration and use
1
DESCRIPTION, CHARACTERISTICS AND CONTENT
Description
The LINK-BASE system, along with LINK-GSM and a SIM
card (not supplied by Erreka), can be used to open doors
and gates by way of missed call from a GSM mobile
device or landline telephone.
The system uses the GSM network, meaning it has
multiple applications (doors and gates, barriers, garage
doors, etc.).
It can be used in any place with GSM coverage, and the
missed call can be made from any place via mobile or
landline phone.
LINK-BASE Module characteristics
• Power supply; 12/24VAC or 12/32VDC
• Two voltage-free relay outputs (1A, 30VDC)
• GSM Module connector (LINK-GSM)
LINK-GSM Module characteristics
• Quadband 850/900/1800/1900 MHz
• Maximum length of the telephone number: 11 digits
Contents supplied and relevant parts
1 LINK-BASE Module
2 LINK-GSM plug-in card with antenna
(ANT)
A Bluetooth card connector
(LINK-BT - card not included)
B RSD radio card connector
(RSD-433 or RSD-868 - card not
included)
C Radio memory card connector
(MEMO1000 - card not included)
D LINK-GSM Card connector
P1 Pushbutton 1
P2 Pushbutton 2
DL1 LED 1 (radio memory)
DL2 LED 2 (GSM signal)
DL3 LED 3 (bluetooth)

For further information on the LEDs, see the section "Installation
and start-up" in the "LINK-BASE" manual.
The calls are free of charge (this may vary, depending on
the mobile telephony operator). The GSM module
rejects the call from the authorised number and runs
the on or off action. Unknown calls are ignored.
Authorised users are added or removed by SMS.
• Bluetooth card connector (LINK-BT)
• RSD radio card connector (RSD-433 or RSD-868)
• Memory
(MEMO1000)
• Up to 500 authorised telephone numbers
• Up to 5 telephone numbers as administrators
A
B C
DL2 P2
DL1
DL3
Txd Rxd GND
12 - 24V
ST1 ST2
card connector for
D
P1
ANT
1
+5V
English
radio codes
2
C256A
25