Information Codes - Dacor DOP36M96GL Manual De Instrucciones

Troubleshooting
Problem
The oven racks
are difficult to
slide.
The oven door is
locked.

Information codes

Oven
Displayed
code
C-d0
C-d1
C-F0
C-F2
C-20
C-21
98 English
NX9900R_PRO RANGE_DOP36M96GL_DG68-01105C-02_EN.indd 98
Possible cause
The shiny, silver-colored racks
were cleaned in a self-cleaning
cycle.
The circuit breaker has been
tripped or there was a power
failure while the oven door was
locked.
Possible cause
This code occurs if the control key is
short for 1 minute.
This code occurs if the door lock is
mispositioned.
This code occurs if communication
between the Main and Sub PBA is
interrupted.
This code occurs if communication
between the Main and Touch is
interrupted.
The oven sensor is open when the
oven is operating.
The oven sensor is short when the
oven is operating.
This code occurs if the internal
temperature rises abnormally high.
Solution
Apply a small amount of
vegetable oil to a paper towel,
and then wipe the edges of the
oven racks with the paper towel.
Activate Control Lockout, and
then unlock the control. See the
Child Lock section on page 68.
Solution
Clean the buttons and make sure
there is no water on/around
them. Turn off the oven and try
again. If the problem continues,
contact a local Dacor service
center.
Press OFF, and then restart the
oven. If the problem persists,
disconnect all power to the oven
for at least 30 seconds and then
reconnect the power. If this does
not solve the problem, call for
service.
Restart the appliance.
2019-07-29 10:52:51