Accessory Installation - WEG CFW500 Guía De Instalación, Configuración Y Operación

Installation, Configuration and Operation Guide

4. ACCESSORY INSTALLATION

The accessory is easily installed or replaced. For correct installation of the accessory
execute the following steps:
Step 1: With the aid of the installation CD, install the virtual serial port driver. For
further details refer to the installation manual available in the CD-ROM.
Step 2: With the inverter de-energized, remove the front cover of the Inverter (figure
A.1 (a)).
Step 3: Remove the accessory (connected plug-in module) if any, as in figure A.1 (a).
Step 4: Fit and press the accessory to be installed as indicated in figure A.1 (b) and
then assemble the front cover of the inverter.
Step 5: Connect the cable to the terminals of the plug-in module (mini-B connector)
and microcomputer (USB type A).
Step 6: Energize the inverter and check in display if the P0027 parameter indicates
the number 5 (P0027=5). If this information is not true or the display of the HMI won't
turn on, check if the module used is actually the CFW500-CUSB, if the DIP-switches
S2.1 and S2.2 are OFF and repeat steps 2-6.
- English -
6 | CFW500-CUSB