Programming By Keypad - Bentel Security B-TEL2 Manual De Instalación Y Usuario

The dialer's keypad can be used to set all the parameters necessary for dialer operation, as well as modify the
dialer's operations to suit the user's specific needs and installation.
The appropriate software or the dialer's keypad, with the auxiliary display, can be used to program these
parameters. When programming by keypad, the parameter is selected by pressing a series of keys.
The value for that parameter is then entered.
Restore Factory Settings
To restore all factory settings, remove all power supplies, hold down the
replace the power supplies.
Access Programming Mode
In order to program parameters by keypad, an Installer PIN must be entered via the keypad in the following
manner:
where <Installer PIN> is a number 4 to 6 digits long. The factory-set installer PIN is 0001.
The device will indicate that it has successfully entered programming mode with a letter
If a PIN longer than 6 digits or an incorrect PIN is entered, the speaker will emit an error sound (boop).
If, at any point during programming, 5 minutes elapse without a key being pressed, the dialer will
automatically exit programming mode.
Programming values
Unless otherwise indicated, values are programmed in the following manner:
where <Section Number> is a 3-digit number and <Value> is the data to be programmed. For a complete list
of sections, refer to Tab. 3.
@
When the key is pressed, the letter
being programmed can be entered.
?
If the key is pressed again while the <Section Number> is being entered, dialer will exit the section and
return to the standby state
Confirm programmed values
C
Press the key to confirm and store the entered value.
Deleting a value
When programming a value, pressing the
display). When the correct digit is entered, it will appear on the display in the place of the incorrect digit. If the
key is pressed repeatedly, it will advance until it reaches the beginning of the entered value, without exiting from
the section.
34

PROGRAMMING BY KEYPAD

INTRODUCTION INTRODUCTION
INTRODUCTION INTRODUCTION INTRODUCTION
A
?
<Section Number>
b
will appear on the display. At this point the value relative to the section
A
C
<Installer PIN>
@
<Value>
key will delete the last digit entered (currently shown on the
   ?
, , and togheter, and then
P
C
on the display.
A
B-TEL2