Rear Panel Features; Lcd Features - Numark CDN450 Guia De Inicio Rapido

REAR PANEL FEATURES

1. POWER PLUG CONNECTOR – Plug your supplied power cord in here.
2. CONTROL CABLE CONNECTOR – Plug in the 8-pin cable included in here to connect the control unit and transport
unit together.
3. RCA AUDIO CONNECTORS – Connect your CD player to your mixer from this line level output.
4. DIGITAL AUDIO OUTPUT – The format is type 2, form 1, also known as S/PDIF (Sony/Phillips Digital Interface Format).
In order to use the digital output you should not use variable pitch slider and the pitch bend buttons. If you adjust the
pitch, other devices may not read the digital output properly because the sampling rate changes.
5. REMOTE START CONNECTOR – To use this connector for fader start, connect a fader start cable to a fader start-
compatible mixer.
automatically start playing. When you move the fader away from that side, the unit will stop. Moving the fader back to
the unit side will start play again.

LCD FEATURES

1. PLAY / PAUSE – This shows when the unit
is playing or paused.
2. CUE – Flashing when the unit is setting a
cue point. Lit continuously when the unit is
paused at a cue point.
3. FOLDER NUMBER – Shows the number of
the current folder.
4. TRACK NUMBER – Shows the current
track number.
5. MINUTES – Shows the minutes elapsed or
remaining depending on mode setting.
6. SECONDS – Shows the seconds elapsed or remaining depending on mode setting.
7. FRAMES – The CD player breaks down a second into 75 frames for accurate cueing. This shows the frames elapsed or
remaining depending on mode setting.
8. TIME BAR – Shows either time remaining or elapsed depending on the setting of the TIME button.
9. TIME MODE – Indicates whether the time shown on the LCD is the elapsed time for the track, remaining time for the
track, or total remaining time for the entire CD.
Note: When playing MP3 files, the total remaining time of the CD cannot be shown.
10. BPM – The tempo, which is indicated in BPM (beats per minute). When the automatic beat-counter is on, this indicator
will read "AUTOBPM."
11. PITCH – Shows the percentage change in pitch. When the lock icon is lit, the KEY LOCK button is engaged.
12. LOOP – Indicates when a loop is programmed. When the indicator is flashing, a loop is currently playing. When "IN /
OUT" is shown, a loop is programmed but not currently playing.
13. SINGLE – Shows when the unit is set to play just one track at a time (Single Play Mode). When this is not lit, the CD will
play continuously through all tracks (Continuous Play Mode). This function is controlled by the TIME button.
Note: When in Single Play Mode, "AUTOCUE" will also be shown. When cueing up a new track, playback will start
when the actual audio of the track starts, eliminating the silence at the beginning of the track.
14. CD / MP3 – Shows when unit is playing an audio CD or an MP3 file.
15. MATRIX DISPLAY – Displays folder names and MP3 tag information. (For MP3s recorded in CBR, the bitrate will be
shown. For VBR-recorded MP3 tracks, the display will show "VBR.")
5
4
3
Every time you move the crossfader on the mixer over to the side that the unit is on, it will
2
2
2
1
2
3
4
3