Count-Down Timer - Timex INTELLIGENT QUARTZ Manual De Instrucciones

will need to be reset prior to using the chronograph func-
tion again or before changing to a different mode. (Please
note: button A is disabled when the maximum four hour
time has elapsed and will not function until the chrono-
graph has been reset by pressing button B).

COUNT-DOWN TIMER

The watch provides a count-down timer function.
Special note: The upper hand, lower hand, and 4th
center hand are united during steps 3, 4 and 5 below. As
you move the minute and second hands forward/back-
ward, you will see all three hands reacting to the addition
or subtraction to the length of time for the countdown
timer duration. After pulling the crown out to the middle
position, pressing button C will advance you through the
cycle of hand engagement as follows: Upper hand (press
92
button C) - Lower hand (press button C) - 4th Center hand
(press button C) back to Upper hand....this allows you to
advance through the cycle to engage the hands you need
to adjust to achieve setting the desired length of time to
count down. Pressing the crown in will end the setting
procedure and confirms the values set so far at any point
in this cycle.
SETTING THE COUNTDOWN TIMER
The countdown timer may only be set when the count-
down timer function is not in operation. If the countdown
timer was previously used, it will need to be reset. If the
timer is currently in operation, it must be stopped and
reset in order to set the countdown timer.
1. Press button C until the upper hand is at some point
on the Timer scale. If the Timer has previously been
93