Installation Requirements; Tools & Parts - ELICA KIT0154387 Guía De Instalación, Uso Y Mantenimiento

INSTALLATION REQUIREMENTS

Tools and Parts
Gather the required tools and parts before starting
installation. Read and follow the instructions provided with
any tools listed here.
Tools needed
• Drill
• 1¼" (3 cm) drill bit
• ³⁄₁₆" (0.5 cm) drill bit
• Pencil
• Wire stripper or utility knife
• Tape measure or ruler
• Pliers
• Caulking gun and weatherproof caulking compound
• Vent clamps
• Jigsaw or keyhole saw
• Flat-blade screwdriver
• Metal snips
• Phillips screwdriver
Parts needed
• 6 - 9 AWG wires, one each of the following colors: black,
white, red, blue, gray, and green or green/yellow (ground)
NOTE: The length of the conduit and AWG wires is
determined by the distance between the in-line blower
motor and range hood terminal boxes.
• 11 - UL listed wire connectors
4
Parts supplied
Remove parts from packages. Check that all parts are
included.
Strain relief connector
4.2x8 mm screws
6-wire blower connector
4x1.8 mm flat washers
Rectangular bracket - Motor cover
Bracket- Connector support
6.3x60 mm screws
9-wire blower connector
Strain Reliefs
Ø 12 mm
6x13.5 mm
Torx 20 adapter
Torx 10 adapter
Strap 2.5x95 mm
Ø 15.9 mm
2
6
1
4
2
1
4
1
1
2
1
1
2