Function Check; Maintenance; Restoration; Disposal - GOK SmartBox 1 Manual Del Usuario

FUNCTION CHECK

We recommend that you check the displayed litre values once per year to make sure that they
are correct.
For a simple check, pull the level probe up by its cable so that it hangs above the liquid.
In this status the display device should show 0 litres (+ tolerance).
The probe signal can be checked with menu step "22. Test Current"
At 0 cm fill level  approx. 3.7 – 4.3 mA.
In the event of a considerable deviation, we recommend a replacement. New probe.
New probe/ replacement of the operating medium
If the installation of a new probe is required and/or a change in the operating medium takes
place, then firstly, all of the "standard values" under menu step "9th zero point probe" must be
reset to the factory setting!
It is also necessary to check, and if required, correct all further set values.

MAINTENANCE

See FUNCTION CHECK.

RESTORATION

If the actions described in TROUBLESHOOTING do not lead to a proper restart and if there is
no dimensioning problem, the product must be sent to the manufacturer to be checked. Our
warranty does not apply in cases of unauthorised interference.
If there are continuous fault messages or alarms (only with SmartBox
alarm level on the probe being reached or being undercut, check the connection line between
the signal part and the level probe to see whether it is interrupted or there is a short circuit; re-
install if necessary.

DISPOSAL

To protect the environment, our products may not be disposed of along with
household waste.
The product must be disposed of via a local collection station or a recycling station.

WARRANTY

We guarantee that the product will function as intended and will not leak during
the legally specified period. The scope of our warranty is based on Section 8 of
our terms and conditions of delivery and payment.

TECHNICAL CHANGES

All the information contained in this assembly and operating manual is the result of product
testing and corresponds to the level of knowledge at the time of testing and the relevant
legislation and standards at the time of issue. We reserve the right to make technical changes
without prior notice. Errors and omissions excepted. All figures are for illustration purposes
only and may differ from actual designs.
part no. 28 100 57 f
®
SmartBox 1 / SmartBox
®
2 / SmartBox
®
2 or 3) without the set
17 / 20
®
3