Other Information - Manta 43LUS79T Manual De Instrucciones

Chapter 4
T
Most problems you encounter with your TV can be
corrected by consulting the following troubleshooting list.
1. Check if the fuse or circuit breaker is working.
2. Plug another electrical device into the outlet to make
sure it is working or turned on.
3. Power plug is in a bad contact with the outlet.
4. Check the signal source.
1. Change the color system.
2. Adjust the saturation.
3. Try another channel. Black-white program may be
received.
1. Change the batteries.
2. Batteries are not installed correctly.
3. Main power is not connected.
1. Adjust the brightness and contrast.
2. Broadcasting failure may happen.
1. Press the button to increase volume.
2. Volume is set to mute, press the mute button to restore
sound.
3. Change the sound system.
4. Broadcasting failure may happen.
It is usually caused by local interference, such as cars,
daylight lamps and hair driers. Adjust the antenna to
minimize the interference.
If the antenna is located in the fringe area of a television
signal where the signal is weak, the picture may be marred
by dots. When the signal is extremely weak, it may be
necessary to install a special antenna to improve the
reception.
1. Adjust the position and orientation of the indoor/outdoor
antenna.
2. Check the connection of antenna.
3. Fine tune the channel.
4. Try another channel. Broadcasting failure may happen.
EN EN EN EN EN EN EN EN

Other Information

Black spots or horizontal streaks appear, or the picture
flutters or drifts. This is usually caused by interference
from car ignition system, neon lamps, electric drills, or
other electrical appliance.
Ghosts are caused by the television signal following two
paths. One is the direct path, the other is reflected from
tall buildings, hills, or other objects. Changing the direction
or position of the antenna may improve the reception.
This interference produces moving ripples or diagonal
streaks, and in some case, loss of contrast in the picture.
Find out and remove the radio interference source.
To fix the double support base on the unit by
screws, the installation is completed.
15