Inspection; General Test Instructions - SAF 50S15 Manual De Instrucciones

5. If necessary remove sharp edges from the front edge of the semi-trailer
bolster plate and in the contact to the fifth wheel and ensure that there
is a chamfer on the front edge.
6. Coat the bolster plate of the semi-trailer according to the
manufacturer's instructions with a thin layer of grease, in order to
prevent corrosion Page 25.

7 Inspection

7.1 General test instructions

Danger!
Risk of serious traffic accidents due to the loss of traffic
safety and operational safety which may lead to serious
or fatal injuries.
• Maintenance tasks must only be carried out by authorised
specialist workshops and by staff with the appropriate
training.
• All components which are not in a serviceable condition
must be replaced.
• Screws must only be used once and must always be
replaced by new original SAF-HOLLAND screws.
• The general safety inspection must be performed as per
legal regulationsPage 11.
• It is the duty of the driver to perform a daily inspection of
the vehicle for traffic safety before starting the journey
Page 22.
• SAF-HOLLAND recommends that you perform the
inspections and inspection tasks described in the
"Inspection" chapter. In case of repairs you must always
follow the SAF-HOLLAND repair instructions and
directions.
XL-KP11695BM-en-DE Rev. A · 11.2013 · Errors and changes excluded · © SAF–HOLLAND
7 Inspection
21