Way Manual Lock; Additional Information - Petsafe 300 serie Guia De Inicio Rapido

Installation – Glass Doors or Windows
A mounting adaptor and wall extension tunnels are available to complete
the installation of the cat flap into glass doors or windows. Please visit
www.petsafe.com to learn more about glass installation and to purchase
these accessories.
Working with glass is a skilled job and should be carried
out by a professional glazier. It is not possible to cut holes in toughened glass or
double glazed units except at the time of manufacture. Please consult a glazier.
Installation – Walls
Installation of the cat flap into a wall will require an Installation Adaptor (sold
separately) to ensure performance. Extension Tunnels may also need to be
purchased to ensure that the flap extends completely through the wall. Once this
has been purchased, follow the instructions below.
Important: Check for electrical and plumbing that could be in the wall where you
wish to place the pet door.
1. Attach the supplied Cutting Template to the inside of your wall in the correct
position ensuring that it is the right way up and level (Fig. C).
2. Drill four (4) corner holes with a 12 mm diameter drill bit as marked on the
Cutting Template through the wall. Ensure that the drill remains straight
and level.
3. Using the appropriate tool for your home construction, such as a jig saw, cut
along the appropriate line as indicated on the Cutting Template. (Fig. E).
4. From the exterior of the home, finish cutting the hole through the wall using the
four corner holes drilled through the wall as a guide.
5. Clean the area of any dust, dirt or debris.
6. Slide one installation adaptor plate over the tunnel on the interior frame
and attach it to the back of the frame using the two (2) pan headed
screws (included).
7. From the interior of the home, position the interior assembly on the wall and
mark the four (4) screw holes on the installation adaptor plate attached to the
cat flap. Remove the assembly.
8. Using the proper hardware for your wall construction (not included), drill the
appropriate size holes for your hardware and attach the interior frame with
installation adaptor to the wall.
Optional: Add tunnel extensions (sold separately) to extend the tunnels through
your wall.
9. Attach the two (2) included metal clips into the rectangular recesses on the
remaining adaptor plate with the flat side of the clip flush with the outer face of
the plate.
10. Set the exterior frame on top of the remaining adaptor plate and attach using
the two (2) 16 mm flat head screws (included).
11. From the exterior of the home, place the exterior frame with installation adaptor
attached onto the tunnel of the interior frame and mark the four (4) screw holes
on the installation adaptor plate. Remove the exterior frame.
12. Using the proper hardware for your wall construction (not included), drill
the appropriate size holes for your hardware, and attach the exterior frame
assembly to the wall.
13. Insert the eight (8) blanking plugs into the exterior and interior installation
adaptor plates and the two (2) blanking plugs into the exterior frame.

4-Way Manual Lock

The 4-Way Manual lock allows you to control your cat's access in and out of your
home in either direction. Until your pet is thoroughly familiar with using the cat flap,
it is a good idea to only use the 4-Way Manual lock in the In or Out position only
(Fig. L).
In or Out
Fig. L

Additional Information

For extended information on your PetSafe
and wall installation, helpful training tips, and available accessories, please visit
www.petsafe.com.
Accessories available online
In only Out only
®
Manual-Locking Cat Flap
Fully locked
including glass
3