Publicidad
Idiomas disponibles
Idiomas disponibles
the job, as this may significantly reduce the
exposure level over the total working period.
Protect yourself against the effects of
vibration by maintaining the tool and its
accessories, keeping your hands warm, and
organising your work patterns.
ASSEMBLY
Before any work on the machine (e.g.
maintenance, tool change, etc) as well
as during transport and storage, set
rotational direction switch to the centre
position. Unintentional actuation of the
trigger can lead to injuries.
Charging your screwdriver
When the charger is connected to the
electricity supply, the red diode on the
screwdriver (Pic.2) (2.2) lights up. The
diode lights up while the battery is being
charged.
Under normal conditions of use the
screwdriver can be recharged several
hundred times.
ATTENTION! The recharging process
generates heat in the battery.
Note: The battery that is supplied with
the screwdriver has been charged for test
purposes only and must be fully recharged
before first time use.
First read the safety instructions then follow
the loading instructions. Insert the charging
plug (Pic.2) (2.1) into the charging socket in
the screwdriver. Then connect the charger
to the electricity supply.
Make sure that there are no knots or sharp
bends in the cable.
The charger and the battery have been
designed to be used together.
NEVER use this charger to recharge
cordless tools or batteries from other
manufacturers. The battery will gradually
lose its charge over a period of time, even if
the tool is not used.
The lithium-ion battery is protected against
deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is
empty, the machine is switched off by
means of a protective circuit: The tool no
longer rotates.
WARNING! Do not continue to
press the On/Off switch after the ma-
chine has been automatically switched
off. The battery can be damaged.
WARNING! Recharge the battery
on a non-flammable surface.
Do not recharge the battery for more
than eight hours. The red diode will turn
green when the battery has been fully
loaded.
Disconnect the cable and store the charger
in a suitable place when it is not in use.
It is not advisable to recharge the battery in
temperatures below freezing.
When removing the battery from the
machine, actuate the trigger switch
(3) until the battery is completely
discharged. Unscrew the screws in
the casing and take off the casing shell.
Disconnect the connections on the battery
and remove the battery (see illustration A).
8
Publicidad
