Vibration Information - IKEA FIX A Manual De Instrucciones

Always wait until the machine has
come to a complete stop before placing
it down. The tool insert can jam and lead to
loss of control over the power tool.
Avoid unintentional switching on.
Ensure the trigger is in the off position
before in serting battery pack. Carrying the
power tool with your finger on the trigger or
in serting the battery pack into power tools
that have the switch on invites accidents.
Safety Warnings for battery chargers
For indoor use only.
Double insulated.
Keep the battery charger away from
rain or moisture. Penetration of water
in the battery charger increases the
risk of an electric shock.
Do not charge other batteries. The
battery charger is suitable only for charging
the batteries that were supplied with your
power tool. Otherwise there is danger of fire
and explosion.
Keep the battery charger clean.
Contamination can lead to danger of an
electric shock.
Before each use, check the battery
charger, cable and plug. If damage
is detected, do not use the battery
charger. Never open the battery
charger yourself. Have repairs
performed only by a qualified
technician. Damaged battery chargers,
cables and plugs increase the risk of an
electric shock.
Do not operate the battery charger
on easily inflammable surfaces (e. g.,
paper, textiles, etc.) or surroundings.
The heating of the battery charger during
the charging process can pose a fire hazard.
Children should be supervised to ensure
that they do not play with the battery
charger.
Products sold in GB only: Your product is
fitted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to
BS 1362). If the plug is not suitable for
your socket outlets, it should be cut off and
an appropriate plug fitted in its place by
an authorised customer service agent. The
replacement plug should have the same
fuse rating as the original plug. The severed
plug must be disposed of to avoid a possible
shock hazard and should never be inserted
into a mains socket elsewhere.
Products sold in AUS only: Use a residual
current device (RCD) with a rated residual
current of 30 mA or less.

VIBRATION INFORMATION

Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given
in UL 60745 / CSA C22.2 No. 60745. It
may be used to compare one tool with
another and as a preliminary assessment
of exposure to vibration when using the
tool for the applications mentioned in this
manual. However, using the tool for different
applications, or with different or poorly
maintained accessories, may significantly
increase the exposure level.
An estimation of the level of exposure to
vibration should also take into account
the times when the tool is switched off or
when it is running but not actually doing
7