Fitting The Harness - Stihl BF Manual De Instrucciones

English
If a loop handle is already fitted:
Align the loop handle (1) and secure
N
it in position – see "Adjusting and
Securing the Loop Handle".
If a loop handle is not fitted:
Mount the loop handle – see chapter
N
on "Mounting the Loop Handle".
Mounting the Loop Handle
9
9
8
8
1
5
6
7
10
10
Place the clamp (5) in the loop
N
handle (1) and position them both
against the drive tube (6).
Position the clamp (7) against the
N
drive tube.
Line up the holes.
N
Fit the washers (8) on the
N
screws (9), and insert the screws in
the holes.
14
Rotate the square nuts (10) as far
N
as stop.
Align the loop handle (1) and secure
N
it in position – see "Adjusting and
Securing the Loop Handle".
Adjusting and Securing the Loop Handle
A
Align the loop handle (1) and move
N
it to the most comfortable position.
Distance A must not be more than
55 cm (22 in).
Tighten down the screws firmly –
N
lock the nuts if necessary.

Fitting the Harness

Not all basic power tools are equipped
with a harness and carrying ring.
Fit the carrying ring – see "Fitting the
N
Carrying Ring".
The shoulder strap/harness is available
as a special accessory.
The type of carrying ring, shoulder
strap/harness and carabiner depends
on the market and the basic power tool.
Shoulder Strap
1
Put on the shoulder strap (1).
N
Adjust the length of the strap – with
N
the machine attached, the
carabiner (2) must be about a
hand's width below your right hip.
1
2
BF