Operation - Sears Craftsman 247.88790 Manual De Uso

Ocultar thumbs Ver también para Craftsman 247.88790:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

�����
��������
Now that you have set up your snow thrower for operation, get
acquainted with its controls and features. These are described below
and illustrated on this page. This knowledge will allow you to use your
new equipment to its fullest potential.
Drive/ Auger Control Lock
The drive control is located on the right handle. Squeeze down the
drive control to engage the wheel drive. Release to stop.
The drive control also locks the auger control so you can operate
the chute directional control without interrupting the snow throwing
process. If the auger control is engaged simultaneously with the drive
control, the operator can release the auger control (on the left handle)
and the augers will remain engaged. Release both controls to stop the
augers and wheel drive.
IMPORTANT: Always release the drive control before changing
speeds.
Auger Control
The auger control is located on the left handle. Squeeze the auger
control to engage the augers. Release to stop the snow throwing ac-
tion. The drive control must also be released in order to stop the auger.
���������
�������� ����� ������
��� ���
��� ����

OPERATION

����� �������
��������
���
�����
�������
���������
����
��������
�������
���� ����
Figure 12
IMPORTANT: Refer to Auger Control Test on page 8 prior to operating
your snow thrower. Read and follow all instructions carefully and
perform all adjustments to verify your snow thrower is operating safely
and properly.
Ignition Key
The ignition key must be inserted and snapped in place in order for the
engine to start. Remove the ignition key to prevent unauthorized use of
equipment. Do NOT attempt to turn the key.
Four-Way Chute Control™
This four-way control lever is meant to control the direction and dis-
tance of snow discharge from the chute. Press the button on the knob
and turn it left or right to rotate the chute to the direction that snow will
be thrown. Tilt the lever forward to decrease the distance snow will be
thrown, and backwards to increase distance.
Wheel Steering Controls
The left and right wheel steering controls are located on the underside
of the handles. Squeeze the right control to turn right; squeeze the left
control to turn left.
NOTE: Operate the snow thrower in open areas until you are familiar
with these controls.
10
����� �����
��������
����� ��������
����� �������
����� ��������
�������
������ ��������
������ �������
������
�������� ������� ������
������

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido