Assembly - Sears Craftsman 247.88790 Manual De Uso

�
Figure 1
Figure 2
Figure 3

ASSEMBLY

Your snow thrower has been assembled at the factory except the parts
shipped loose in the carton.
a. Two Spare Shear Pins (with Cotter Pins). May be stowed in
b. This Operator's Manual
�
NOTE: All references in this manual to the left or right side of the snow
thrower are from the operating position only. Exceptions, if any, will be
specified.
1. Cut corners of carton and lay sides flat on ground. Remove all
packing inserts. Move snow thrower out of carton. Make certain
carton has been completely emptied before discarding it.
a. Pull up on upper handle as shown in Figure 1. Align upper
b. Tighten hand knobs securing upper handle to lower handle.
2. Remove wing nut and hex screw from chute control assembly and
clevis pin and cotter pin from chute support bracket. See Figure 2.
Position the chute assembly (forward-facing) over the chute base.
3. Place the 4-way chute control in a centered position. See Figure 3.
4. Place chute assembly onto chute base and secure chute control
assembly to chute support bracket with clevis pin and cotter pin
removed earlier. See Figure 4.
6
plastic dash panel. See Figure 8.
handle with the lower handle.
Figure 4