CP 0022, CP 0032, CP 0069
Operation
WARNING
Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
►
Learn how the machine is switched off in the event
of an emergency.
Stop the machine immediately in all cases of
►
power supply interruption.
Preparations before starting
Check the drilling equipment
♦
Check that all of the drilling equipment is in good
condition.
Check that the impact surface of the drill steel
♦
shank is flat, with no signs of wear.
Make sure that the air inlet and exhaust ports are
♦
free from obstructions.
Check that the flushing holes in the drill steel and
♦
drill bit are not blocked, and that the flushing air
and water flows through without obstruction.
Make sure that the air filter (located in the air
♦
nipple) is clean and not torn or distorted.
♦
Ensure that the fittings are tight and leak-proof.
DANGER
Whipping air hose
A compressed air hose that comes loose can lash
around and cause personal injury or death
Check that the compressed air hose and the
►
connections are not damaged.
►
Check that all compressed air connections are
properly attached.
Blow out the air hose
Every day before using the drill, blow out the air
♦
hose to clear it of accumulated dirt and moisture.
Fill the lubricator with oil
♦
Check that the chuck and drill steel shank are
always covered with a film of oil.
9800 0901 90a | Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
Safety and operating instructions
Controls
Throttle lever
CP 0022 KL
The rock drill is equipped with a throttle lever for
regulating compressed air to the percussion
mechanism.
Throttle valve closed (stop position) (A).
♦
Blow-cleaning only (B).
♦
♦
Throttle lever half open (C).
Throttle lever fully open (D).
♦
17