lamber 050F-add Manual De Instrucciones página 24

DESCALING
When hard water is used you can find inside the machine and also on dishes calcareous sediments which must be
removed both for hygienic and operating reasons by a descaling operation.
Operating process and frequency of this intervention are suggested by your cleansing agent supplier who has suitable
products, generally containing phosphoric acid.
In order to avoid damage to the machine do not increase the quantities and once operations end rinse abundantly.
SANIFICATION
At least each 30 days it would be useful to do this operation which guarantees the complete hygienic conditions of the
machine. We suggest to contact your cleansing agent supplier who will give you quantity and name of the most suitable
product you can use and that is generally an active chloride powder (100÷200 ppm).
In order to avoid damage to the machine do not increase the quantities and once operations end rinse abundantly.
USEFUL HINTS FOR STAINLESS STEEL MAINTENANCE
Stainless steel is so called because it is not affected by oxidation; this dues its resistance to a thin molecular layer of
oxide on the surface which protects againts further oxidation. There are, however, substances which can modify or
destroy this layer, giving rise to corrosion: besides preventing the protective film of oxide from reforming, these
substances corrode the stainless steel itself and can cause irreparable damage. It is therefore necessary to prevent this
by choosing correct cleaning products and by complying with the following simple recommendations: never forget that
when using these appliances, the first and fundamental rule is to guarantee that the cleaning products are both
non-toxic and hygienic.
Before using any detergent to clean either the stainless steel or the immediate and sorrounding floor area, always ask
your supplier for the most suitable product which does not cause corrosion on the steel itself; the onset of rust is most
commonly caused by the use of unsuitable cleaning materials (strongly acid chlorate based detergents) or on inadequate
maintenance.
Our appliances are made of stainless steel AISI 304 (18-10 type) for exterior panelling,upper tops, tanks etc.
Comply with the following instructions when cleaning and servicing parts in stainless steel.
Ordinary daily maintenance
Carefully and frequently clean the surfaces using a damp cloth; use soap and water or normal detergents,so long as
these do not contain abrasives or chlorine based substances such as sodium hypochlorite (bleech) ,hydrochloric
acid or other such solutions:These products quickly and irreparably corrode stainless steel. When cleaning floors
underneath or near the appliances, never use the above mentioned products as vapours or splashes could subject the
steel to similar destructive effects.
Only ever rub in the direction of the satining, then thoroughly rinse with clean water and carefully dry.
Rust : water supply pipes, inevitably convey particles of rust dissolved in the water especially in new installation plants or
when taps are opened after a period of inactivity. These iron deposits must not be allowed to remain on the stainless
steel since they produce rust by contamination.
Use suitable products to remove any rust marks,from companies which produce detergents for industrial use. After
application, thoroughly rinse with clean water, neutralizing the action of the product with an alkaline detergent normally
used to clean such appliances or with another specific product.
DO NOT USE METAL MATS TO CLEAN THE STAINLESS STEEL
24