Switching On The Product; Switching The Product Off - Silvercrest SBSB 750 A1 Instrucciones De Utilización Y De Seguridad

CAUTION! RISK OF DAMAGE
TO PROPERTY!
Remove any large or sharp ob-
jects before you start vacuuming.
Observe the cleaning and main-
tenance instructions provided by
your flooring manufacturer.
Only vacuum curtains and light-
weight fabrics using a low suction
power. Otherwise curtains or
materials may be sucked into
the vacuum and damaged.
Never operate the product if it is
in a vertical position or lying on
its side. The product must be po-
sitioned firmly on the floor when
in operation. Especially when
working on stairs, ensure a level
positioning and sufficient stability.
Switch off the product immedi-
ately if the suction nozzle or the
telescopic wand

Switching on the product

First make sure that all plug connections are
connected to each other correctly and firmly.
Position the product on the floor.
Adjust the telescopic wand
To do so, press the telescopic wand locking
mechanism and slide the sections contained
12
within the telescopic wand
or out of each other (see Fig. B).
Pull out the mains cable until it has reached the
desired length (max. approx. 7.5 m).
Plug the mains plug into a properly installed
mains socket. Ensure that the mains cable is
is clogged.
4
to your height.
4
into each other
4
lying loosely on the floor between the mains
plug and the vacuum cleaner
Ensure that the power control knob
the lowest setting by turning it to the left until it
stops.
Press the foot pedal to switch on the product.
14
Turn the power control knob
until the desired power output is reached.
When vacuuming, make sure to work at an
even speed. You do not need to exert additional
pressure on the nozzle.
Note: For very dirty surfaces, use the maximum
suction power in order to achieve a high cleaning
effect.
Note: If you have accidentally vacuumed
something up, you can use the airflow regulator
to reduce the suction strength (see Fig. D):
17
If you close the airflow regulator
in a high suction power.
If you open the airflow regulator
power is reduced.

Switching the product off

Press the foot pedal to switch off the product.
14
Unplug the mains plug from the mains socket.
Press the foot pedal to rewind the cable
order to wind up the mains cable. The mains
cable rolls up automatically.
CAUTION! RISK OF INJURY!
Retracting the mains cable too
vigorously may lead to the mains
cable swinging from side to side
(whip effect). There is a risk of
injury. Therefore you should hold
onto the mains cable when rolling
it up.
Note: Ensure that you do not wind up the
mains cable too quickly, in order to prevent it
becoming jammed / knotted.
.
1
is set to
13
to the right
13
, this results
17
, the suction
17
in
16
GB/MT 35