Fanimation PYRAMID LP8406 Manual De Instrucciones página 13

How to Assemble Your Light Kit or Cap (continued)
3. Remove one of the three screws in the light plate
assembly. Retain the screw for later and slightly
loosen the remaining two screws. (Figure 3)
5A. For use with light kit.
Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 5A)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
NOTE: If you have installed your fan with the
cap, skip Steps 6 and 7.
6. Assemble the LED assembly to the light plate
assembly using the two key slots. Replace the
removed screw from Step 3 and secure all three
screws. (Figure 6)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
7. Secure the light shade to
twisting in a clockwise direction. Do not over-tighten.
(Figure 7)
steel
light plate assembly by
Light Plate
Assembly
Light Kit
Wire Cover
Figure 5A
Light Plate
Assembly
LED Assembly
13
Figure 3
Figure 4
Light Plate
Assembly
LED
Assembly
Figure 5B
Figure 6
Light shade
Figure 7
Light Plate
Assembly
Steel Cap
Light Plate
Assembly