How To Install Your Canopy Housing; How To Assemble Your Ceiling Fan Blades - Fanimation PYRAMID LP8406 Manual De Instrucciones

How to Wire Your Ceiling Fan (continued)
4. Once the connection has been made, slide the
receiver into the hanger bracket, taking care not to
pinch the wires. (Figure 5)
NOTE: This step is applicable after the neccessary wiring is completed.
Remove one of the two shoulder screws in the
1.
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1a)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw
cover over the shoulder screws in the hanger bracket
utilizing the keyslot twist-lock feature. (Figure 1b)

How to Assemble Your Ceiling Fan Blades

1. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
screws and flat washers to secure the blade to
the blade holder. (Figure 1)
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.

How to Install Your Canopy Housing

WARNING
CAUTION
Hanger Bracket
Figure 1a
Screw with Flat Washer
Blade
HARDWARE USED:
SERRATED HEAD
SCREWS
Flat WASHER
11
Receiver
Figure 5
Canopy Screw
Cover
Figure 1b
Figure 1
Blade Holder
x 12
x 12