Publicidad
Idiomas disponibles
Idiomas disponibles
of excessive dust. Do not operate the UPS outdoors.
To power up the UPS, connect the ac input connector to
the utility power.
The UPS charges its battery whenever it is connected to
utility power. For best results, charge the battery for four hours during initial use.
Connect the loads to the output hardwire connector.
Apply the electrical shock
warning label to the panel, in a way that is clearly visible to the user.
The output connector will provide protection from surges
and power failures to the critical loads.
After connecting the UPS to the utility
button immediately. The Green Mode is enabled, i.e. if a load less than forty
watts (or no load) is connected and the UPS operates in the Backup Mode.
The UPS will enter into the Green Mode status after three minutes of backup
to prevent deep discharge of the battery. To reactivate the unit, power the unit
OFF then ON again or reapply utility power.
After connecting the UPS to the utility
power, press the ON button and keep pressing it until you hear two short
beeps "Bi-Bip", then release the button immediately. The Green Mode is now
disabled. Any kind of load, whether smaller than forty watts or larger, will not
affect the normal operation of the UPS under Ac or Battery Mode.
To switch OFF the UPS, press and hold the Power ON/OFF/Test
button until the "Ac Power Normal" LED or "ON Battery" LED turns OFF.
English version
Publicidad
