Publicidad
Idiomas disponibles
Idiomas disponibles
Your pressure washer requires some assembly and is
ready for use only after it has been properly serviced
with the recommended
oil and fuel.
If you have any problems
with the assembly
of
your pressure
washer,
please call the pressure
washer helpline at 1-800-222-3136.
IMPORTANT:
Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure.
REMOVE
PRESSURE
WASHER
FROM CARTON
•
Open carton and slice two corners opposite guide
handle from top to bottom so the panel can be
folded down flat.
•
Remove hose reel box, fillers, and parts box
shipped with your pressure washer.
•
Roll the pressure washer out the open end of the
carton.
•
Raise guide handle, secure in place.
Lift the handle to upright
position and slide the
locking caps into place
•
Check carton for additional loose parts.
CARTON
CONTENTS
Check all contents. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
•
The main unit
•
Hose reel components
•
Parts box (which includes items listed below)
High pressure hose
Spray gun
Nozzle extension with Hi/Lo adjustable nozzle
Engine oil
Quick connect fitting
Owner's manual
Nozzle cleaning kit
O-Ring kit
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration shown on page 7. If any parts are missing
or damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING
YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
•
Attach hose reel.
•
Add oil to engine crankcase.
•
Add fuel to fuel tank.
•
Connect high pressure hose to the spray gun and
the pump.
•
Connect water supply to the pump.
Assembling
Hose
Reel
IMPORTANT: You must take the hose off the reel
when operating your high pressure washer. The reel is
for storage purposes only.
•
Attach the handle to the reel with Iocknuts, flat
washers, and bolts as shown.
•
Secure the hose reel to the left side upright, (from
behind the unit), with Iocknuts, flat washers, and
bolts. See page 7 for location.
-- M6 Bolts
M6 Flat washers
M6 L!ck washer
M8 Bolts
M8
M8 Flat washers
Publicidad
