Genius LYNX 06 Instrucciones Para El Uso página 23

system is operating correctly.
Whenever you access the display of the operating parameters,
or if power is cut, during the first cycle the control unit
automatically performs the work cycle learning procedure.
While the work cycle is being learned, the automated system
does not perform any slow-downs.
12. PROTECTIVE FUSES
Two protective fuses are located on the control unit – see Lay-out. If
one of these two fuses has to be replaced, observe the specifications
indicated in the following table:
Fuse
Transformer primary winding / Power to
F1=T5A 250V 5x20
F2=T500mA 250V 5x20 Power to accessories / Indicator Light
13. DISPOSAL
The trash container symbol shown on the product label,
on the product or in the instructions indicates that the
product, at the end of its life, must be disposed of sepa-
rately from other waste products.
The user must therefore bring the equipment that has
reached the end of its life to an authorised electrical
and electronic waste disposal centre, or return it to the
dealer when new equivalent equipment is purchased, on
a one-to-one basis.
Proper separate collection for the recycling, treatment or compatible
environmental disposal of the equipment no longer in use contributes to
avoiding negative effects on the environment and health and favours reuse
and/or recycling of the materials with which the equipment is made.
Unlawful disposal of the product by the user is subject to fines provided
for by the regulations in force.
Protection
motor
LYNX 06 Page 19
Guide for the installer