Avanzini Drago Instrucciones De Montaje página 37

Position the Drago Control to make the 2
-
setup the flame, it is necessary to operate on the EV2 valve: un-
screw the cap placed at the center of the solenoid valve and then,
using a 4 Allen wrench, turn (as in photo
decrease the quantity of gas) or anticlockwise (to increase the
quantity of gas).
-When you have finished setting the calories per hour necessary
-
for the oven, remember to screw the cap back on and then adjust
the primary air on the 2
The calories per hour that are necessary for a correct operation of
-
the oven are obtained when 1
gether) reach the center of the oven dome. In general, when an ov-
en (that has been turned off the day before) takes 60/80 minutes to
reach the set temperature (the time range can vary depending on
the oven measurements), we consider the burner to supply the cor-
rect amount of Kcal/h.
FOTO 3
nd
flame torch (as in photo
st
flame and 2
nd
flame turn itself on. To
3 ) either clockwise (to
3
4 ).
4
nd
flame (burning to-
FOTO 4
37