Cleaning The Pump - Holmatro GBP10EVO3 Manual Del Usuario

6.4.2 Inspection
• Check the pump for completeness, leaks and damage. Do not use the pump if it leaks or is
damaged and contact the Holmatro dealer.
• Check the battery level and charge the battery again, if necessary. Refer to section 5.11.
6.4.3

Cleaning the pump

• Make sure the pump has cooled down.
• Clean the pump and any accessories before storage.
• Clean the couplers.
• Dry the pump if it was used in wet conditions.
6.4.4 Storing the battery pack
NOTICE
When the battery pack is not in use, it is advised to keep the battery pack connected to the
battery charger (connected to a power source) at all times. When the battery pack is full, the
battery charger automatically switches on and off at regular intervals to keep the battery
level at 100%.
• Store the battery pack in a dry and well-ventilated area. The maximum storage temperature (see
section ) may not be exceeded.
• Make sure the equipment can not fall over during transport.
7 Troubleshooting
7.1 General
Consult the Holmatro dealer if the listed solutions do not give the desired result, or in case of other
problems.
For malfunctions or repair, always specify the model and serial number of the equipment.
NOTICE
If the pump has to be returned to the dealer for repairs, make sure that the pump is turned
off, i.e. the switch is in the OFF position.
7.2 The pump does not work when the on/off switch is operated
/i
Possible cause
The battery condition is poor.
The pump is not activated.
The battery pack is in the sleep mode. This
happens when the tool is not used for about
10 minutes.
The electric motor does not work.
GBP10EVO3
Solution
• Check the battery condition by pressing the SOC
indicator button. See section 3.6.
• Replace the battery pack by a fully loaded battery
pack.
Activate the on/off switch.
To activate the battery pack again:
• Press the SOC indicator button, or
• Reinstall the battery pack.
Have it repaired by a Holmatro Certified Technician.
916.400.220_001
EN
41