First Use And Set-Up Preparation - mspa Alpine Manual Del Usuario

REF. NO.
A
B
C
D
E
F
G
H
I
J Buckle spa cover and ground mat set (For D-AL04GS/06GS, D-TE06GS)
K
NOTE: When ordering parts, be sure to quote the model number and part numbers.

FIRST USE AND SET-UP PREPARATION

Site preparation and requirements
● The spa can be installed indoor and outdoor around 10 minutes by at least one person. For household use
only.
● The spa must be set up on a flat, smooth and supporting surface that is capable of supporting the
maximum load of the filled spa with listed maximum occupants.
● Make sure the area is free of sharp objects under or around the spa. Uneven of unsound surfaces can
damage the spa and void your warranty. Level the surface before filling spa with water.
● Provide adequate drainage system around the spa to deal with overflow water and splashes.
● Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance
and/or service.
Additional requirements for indoor installation
● Verify the supporting floor can support the filled weight of spa with maximum number of occupants. Check
with a qualified contractor or structural engineer to verify the requirement.
PARTS DESCRIPTION
Spa cover with aluminum foil inside
(Square shaped spa comes with a ground mat with the cover)
Digital lock (for D-NE02GS, D-SC04GS/06GS,
D-AU04GS/06GS, D-CA04GS/06GS, D-ST04GS)
Spa drain valve adaptor
Wicker side bar (Only for Nest D-NE02GS)
Spa tub
Wired controller
Filter cartridge
Repair kit
Wrench
Instruction DVD
10
QTY.
1
1
1
1
1
1
1
1
1
1
1