mspa Alpine Manual Del Usuario página 13

Ocultar thumbs Ver también para Alpine:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Note:
Check before inflation whether the manometer cap is screwed up tight on the valve of pool
body. If not, please tighten and then inflate. After inflation, the manometer cannot be removed,
otherwise air will be released.
When the Yellow section is pushed out, the Spa inflation is completed. You can fill the Spa with water.
After water filling is completed. Check air pressure once again to ensure the manometer reaches
Green section. Always ensure the manometer is on Green section at use.
If the White section of the manometer appears, the spa is over inflated. Rotate the valve cap counter
clockwise, have the air released till the Green section is pushed out, then tighten it clockwise.
To avoid over inflation caused by warm weather or sunshine when leaving spa for weeks inflated and
filled with water in temperature higher than 20°C (68°F), please release some air to make sure the
manometer is always on Yellow section.
NOTE: Deflation Instruction
Spa Deflation
1. Unscrew the manometer cap on the spa pool to deflate the spa.
2. Once the deflation is completed, replace the cap back.
Water Filling
4.
4.1 Check the spa liner is at the selected area and point
the drain valve toward a suitable draining area before
filling water.
4.2 Fill the spa tub with fresh water to a level between
Minimum and Maximum line marked on the
inside of the spa wall.
Do not over fill the spa. It is recommended to fill the spa with lukewarm water for quick heating and
energy saving.
WARNING:
● Water level must reach the Minimum water line but not exceed the Maximum line to avoid
pump failure.
● Never pour water with a temperature higher than 40°C(104°F) into the spa directly.
● To avoid control system failure, do not operate the spa until water reaches the Minimum
line.
4.3 After water filling, double check the spa pool air pressure to make sure the manometer points out the
Green section.
4.4 Place the zipper spa cover over the spa tub, and make sure the spa cover zipper are closed and lock
the cover by the digital lock in the accessory pack.
4
13
Yellow
Green
White

Publicidad

Tabla de contenido
loading

Tabla de contenido