Controller Operation - mspa Alpine Manual Del Usuario

CONTROLLER OPERATION

Heater Button
Bubble Button
Up Button
Temperature display: press RESET on PRCD, read the current temperature on the screen.
Heater Button:
The filter will automatically be running for 15 seconds to test the working condition once the
HEATER
HEATER function is started. It there is no abnormality, the heater will keep working until the water
temperature reaches the set value. After the water temp is lower than the set temp, the heater will
restart to heat the water automatically. The HEATER button displaying red means that the heating
system is activated. The HEATER button displaying green means that the system is at rest and
keeping the water in set temp.
Filter Button:
green when activated.
FILTER
NOTE: Filtration cannot be turned off when Heating is activated. When the Heating function is
turned off, Filtration will be stopped after 30 seconds. Filtration function can be then activated
separately.
NOTE: Auto-filtration system automatically activated every 4 hours.
Bubble Button:
green when activated. The bubbling will be shut down automatically after every 20 minutes
BUBBLE
operation for safety concern .It can be re-activated 10 minutes after shutdown.
Attention: The bubble function can only be activated when the inflation knob is in <OFF> position.
HEATER
BUBBLE
UP
Press HEATER button to start or stop heating.
Press FILTER button to turn the function on/off. The light of FILTER button display
To activate the bubbling massage function. The light of Bubble button displays
°C
FILTER
TIMER
DOWN
15
Filter Button
Timer Button
Down Button