Angelcare AC401-A Manual Del Usuario página 17

5.3 - CHANGING THE MOVEMENT AND SOUND MONITORING FUNCTIONS
TO SET DETECTION MODE:
1
2
Movement Only
Sound Only
"TIC", Sound & Movement
Sound & Movement
"TIC" & Movement
TO TEST SENSOR PAD
MOVEMENT OR "TIC" MODE NEED TO BE ACTIVATED:
1
MOVEMENT ALARM
• If NO movement is detected after 15 seconds you will hear a single "TIC" pre-alarm
sound from the Nursery Unit.
• If after a further 5 seconds there is still NO movement detected both the Parent Unit
and Nursery Unit speakers will a emit loud warning sound.
• Nursery Unit icon flashes on the Parent Unit
• Green light on the Nursery Unit will turn OFF to indicate NO movement is being
detected.
IF THE ALARM DOES NOT SOUND
• Avoid contact with crib while Sensor Pad is in operation.
• Place crib near a supporting wall.
• Adjust the Sensor Pad sensitivity level.
3
2
1) Press the MENU button once and
the flashing icons will appear.
2) Use the UP and DOWN Arrows to select
your preferred detection mode.
3) Press the SELECT button to confirm
your choice.
4) Press the MENU to view the next option,
or EXIT if you wish to stop programming.
If you press the MENU button for too long
the unit will go in to connection mode and the
Out-of-Range indicator will start flashing. If this
happens, wait 20 seconds and then press
the MENU to start again.
1) Move your hand lightly on the mattress.
Pendulum icon will appear
on Parent Unit indicator bar.
It will move as you move your
hand and trigger a "TIC" sound.
2) Remove your hand from the mattress.
After 15 seconds you will hear a
"TIC" pre-alarm sound, and 5 seconds
later the Movement Alarm will trigger.
3) Repeat by moving your hand lightly in
all four corners of the mattress. Ensure
the Nursery Unit Movement Indicator is
still flashing.
E
N
17