Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2
SAFETY PRECUATIONS
2.1
INSTRUCTIONS FOR THE INSTALLER
•
Make sure that the place of installation of the replace meets
all local, national and European rules and regulations.
•
Comply with the indications given in this manual.
•
Check that the ue and air intake are suitable for the type of
installation opted for.
•
The electrical connection must not be done using temporary
or non-insulated leads.
•
Check that the earthing of the electrical system is ef cient.
•
Always use the individual safety devices and the other
protection gear as established by law.
2.2
INSTRUCTIONS FOR THE USER
•
Prepare the place of installation of the replace in accordance
with the local, national and European rules and
regulations.
•
Since the replace is a product that heats, its outer surfaces
can get very hot.
•
For this reason we advise maximum caution when it is
working, in particular:
1.
Do not touch or go near the glass door as you could
get burnt;
2.
do not touch the smoke discharge;
3.
do not empty the ashes;
4.
do not open the door except for normal discharge
operations;
5.
do not do any type of cleaning;
6.
make sure that children are kept away.
•
Comply with the indications given in this manual.
•
Only use fuel that complies with the indications given in the
chapter referring to fuel chacteristics.
•
Scrupulously perform the intended maintenance operations.
•
Do not use the replace if there is a malfunction.
•
Do not throw water on the replace when it is lit or to put the
re out in the hearth.
•
Do not lean against the open door.
•
Do not use the replace as a support or anchor of any type.
•
Do not clean the replace until the structure and ashes are
completely cold.
•
All work must be carried out in maximum safety and calmly.
•
Do not use the appliance as an incinerator for waste.
•
In case of stove malfunctioning due to an insuf cient
ue draught, have it cleaned carefully by a specialised
technician.
•
In the event of a chimney re, attempt to extinguish the
re by closing the primary air required for combustion,
and then by smothering the ame. Immediately call for
emergency assistance (do not throw water on it).
30
INSTALLATION
00 477 0152 -04/2017 - PALAZZETTI - PN - I
2.3
PRECAUTIONS FOR THE MAINTENANCE
ENGINEER
•
Comply with the indications given in this manual.
•
Always use individual safety devices and other protection
means.
•
Before undertaking any maintenance, if the replace has been
used, it must be completely cold.
•
Disconnect the electrical power supply before performing
any work on the electrical or electronic parts or on the
connectors.
TALY
Publicidad
Tabla de contenido
