8.5
CLEANING THE FLUE
In normal operating conditions, the ue should be cleaned
every 40 quintals of wood burnt or at least every two
years, unless regulated differently.
At any rate, clean at least once a year. When cleaning
we suggest removing the smoke diaphragm from the
smoke outlet to enable the soot to fall, to be replaced
once cleaned. (See Chapter 6.4)
Warning! If the diaphragm is not put back there would
be a strong depression (forge effect)and the wood would
burn too quickly and irregularly.
8.5.1
POOR SMOKE DRAUGHT
If this occurs the rst times you light the wood insert, check
that the ue is not clogged with masonry debris, birds'
nests or anything else in the chimney top. Furthermore,
the ue should be connected according to the instructions,
without any chokes and with the ue ttings hermetically
sealed. If this problem occurs after a period of normal
operation check and clean the ue.
9
INFORMATION FOR DEMOLITION AND
DISPOSAL
Demolition and disposal of the wood insert
is the sole responsibility of the owner.
Dismantling and disposal may be entrusted
to a third party provided we are talking
about a company authorised to salvage
and eliminate said materials.
In all cases you must abide by the laws
in force in the country of installation as
regards the disposal of materials and, if
necessary, the report of disposal.
All dismantling operations for demolition
must take place when the wood insert is
still.
Contact the local authorised waste disposal
company to scrap the wood insert structure
Dumping the product in accessible areas
is a serious hazard for both people and
animals.
The owner is always responsible for injury
to people and animals.
When the wood insert is demolished,
the EC mark, this manual and all the
other documents relative to it must be
destroyed.
The picture of the bin crossed is labelled
on the equipment, and it means that when
the device is out of use it has to be kept
separated by other wastes.
44
INSTALLATION
00 477 0152 -04/2017 - PALAZZETTI - PN - I
In this case both the fan kit:
On the basis of Article 13 by Legislative
Decree n°151 of 25th July 2005 actuation
of the European Directive 2002/96/CE of
23rd February 2003 on waste electrical
and electronic equipment. It is connected
to the policy and action which aim to
the prevention of waste electrical and
electronic equipment,named RAEE, and
in addition, the reuse, recycling and other
forms of recovery of such wastes so as to
reduce the disposal of waste. It also seeks
to improve the environmental performance
of all operators involved in the life cycle of
electrical and electronic equipment.
TALY